![]() It will probably have the name enp2s0, enp1s1, etc. extern0: the network card connected to the external network (or WAN).On an actual computer it will probably have the name enp2s0, enp1s1, etc. intern0: the network card connected to the LAN.Throughout the following sections of this guide, the convention stated below is used: in order to highlight their different networks to which they connect. However you might want to rename your interfaces e.g. These are persistent and will not change when you reboot. Systemd automatically chooses unique interface names for all your interfaces. Network interface configuration Persistent interface naming A hub, switch or UTP cable: You need a way to connect the other computers to the gateway.One interface must connect to the external network, while the other connects to the internal network. You will need to be able to connect those networks to the same physical computer. At least two physical network interfaces: a gateway connects two networks with each other (actually a router can be made using a single physical interface that underlays two VLAN interfaces and is connected to a VLAN-aware switch, so-called router-on-a-stick configuration, but it is not covered in this article).The base install will take up around 500MB of space and if you want to use a caching web proxy, you will need to reserve space for the cache as well. The reasoning is further explained in #Persistent interface naming. Note: Throughout the article, intern0 and extern0 are used as names for the network interfaces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |